本文關鍵詞： 鋁基復合材料 正交試驗法 攪拌因素 密度 磨損率　出處：《上海金屬》2017年03期 　論文類型：期刊論文

【摘要】：采用攪拌鑄造法,以SiC顆粒為增強相,制備鋁基復合材料。以所得試樣的密度和磨損率為目標函數,以攪拌溫度(A)、攪拌速度(B)、攪拌時間(C)為變量進行正交優化設計。結果表明,攪拌因素對復合材料密度的影響順序?yàn)?BCA;對磨損率的影響順序?yàn)?BAC。制備SiC增強鋁基復合材料的最佳工藝參數為:攪拌溫度780℃,攪拌速度300 r/min,攪拌時間40 min。
[Abstract]:Aluminum matrix composites were prepared by agitation casting with SiC particles as reinforcement phase. The density and wear rate of the obtained samples were taken as objective functions, and the orthogonal optimization design was carried out with the variables of stirring temperature, stirring speed and stirring time. The effects of stirring factors on the density of the composites are in the order of: (1) BCA, and the order of influence on the wear rate is: (1) BAC. the optimum technological parameters for the preparation of SiC reinforced aluminum matrix composites are as follows: stirring temperature 780 鈩，

本文編號：1514413