本文選題：金山店鐵礦 + 多中段通風　； 參考：《武漢科技大學》2013年碩士論文

【摘要】：金山店鐵礦由于張福山村搬遷滯后，，東區下降速度明顯低于西區，形成了-340m中段、-410m中段同時開采局面，造成整體通風系統回風混亂，東、西區難以形成安全有效通風網絡。依據金山店鐵礦礦區現有通風系統分布及中段平面布置狀況，基于ANSYS—CFX流體模擬軟件，提出了以負壓截面代替風機出口處負壓的建模方法，構建了礦區整體通風模擬網絡三維模型。系統模擬了現有通風網絡的風流流線分布及風流流動方向，辨識出多中段開采時-410m中段污風對-340m中段的風流污染以及礦區存在局部通風不良區域等問題。為尋求多中段開采通風優化系統，選取金山店鐵礦老副井-340m中段回風、老副井-270m中段回風、新回風井-340m中段回風、新回風井-270m中段回風四種可行方案，模擬分析了各方案的進風井風速及出風口負壓，以滿足風量要求和風機能耗最小為原則，確定了新回風井-270m中段回風為最優方案。利用正交試驗分析方法，選取中央溜破系統風機負壓、西回風井風機負壓、東區新回風井風機負壓為研究對象，分別對老主井、西回風井、新回風井出口風速進行了三因素三水平顯著性方差分析，建立了選擇風機負壓參數調節風量分配的風機負壓—出口風速函數，實現了通風系統風量、風壓優化分配。 利用ANSYS—CFX流體模擬軟件，以負壓截面代替風機出口處風壓技術建立的礦區整體通風系統模擬模型，實現了通風系統存在問題辨識，方案優化，通風系統參數選擇，克服了礦山網絡模擬不能實現礦山整體模擬的不足，具有較強的適用性。
[Abstract]:Due to the lagging of the relocation of the Zhang Fushan Village, the decline rate of the east area is obviously lower than that in the west area. The middle section of the -340m is formed, and the middle section of -410m is simultaneously mined, resulting in the chaos of the whole ventilation system, and the safe and effective ventilation network is difficult to form in the East and west area. Based on the ANSYS - CFX fluid simulation software, the modeling method of negative pressure cross section instead of the negative pressure at the outlet of the fan is put forward. A three-dimensional model of the whole ventilation simulation network in the mining area is constructed. The flow line distribution and the flow direction of the existing ventilation network are systematically simulated and the wind flow in the middle section of the -410m section of the middle section of the -340m is identified. In order to find the ventilation optimization system in the middle section of the multi middle section, select the return air of the -340m middle section of the old auxiliary shaft of Jinshan iron mine, the return air in the middle -270m of the old auxiliary shaft, the back air in the -340m middle section of the new return air well and the return air of the new return air well, -270m middle section, and simulate and analyze the wind speed of the air wells in each scheme and the analysis of the wind speed in each scheme. In order to meet the requirement of air volume and the minimum energy consumption of the fan, the optimum scheme for the return air in the -270m middle section of the new return air well is determined. By using the orthogonal test analysis method, the negative pressure of the fan in the central slip system, the negative pressure of the West return air blower and the negative pressure of the new return air fan in the east area are selected as the research object, and the old main well, the West return air well and the new return are respectively returned. The wind shaft outlet wind speed has been analyzed by three factors and three level significant variance analysis. The negative pressure outlet wind speed function of fan is set up to adjust the air flow distribution of the fan negative pressure parameters, and the ventilation system air volume and the wind pressure are optimized.
Using the ANSYS - CFX fluid simulation software, the whole ventilation system simulation model of the mining area is established by the negative pressure section instead of the wind pressure technology at the outlet of the fan. The problem identification of the ventilation system, the optimization of the scheme, the selection of the ventilation system parameters have been realized, and the shortage of the mine network simulation can not be realized in the whole simulation of the mine is overcome, and it has strong applicability.

【學位授予單位】：武漢科技大學
【學位級別】：碩士
【學位授予年份】：2013
【分類號】：TD724

【參考文獻】

相關期刊論文 前10條

1 董志周;;新建路隧道東線通風模擬分析[J];城市道橋與防洪;2008年12期

2 丁永明;李誠玉;陸衛東;李大方;;葦湖梁煤礦通風系統的優化[J];礦業安全與環保;2011年01期

3 王新;;基于CFX軟件的瓦斯爆炸災害氣體擴散模擬[J];遼寧工程技術大學學報(自然科學版);2011年01期

4 朱曉天;羅智星;yN麗;王建康;;熱壓通風建筑的風路設計與風場模擬[J];建筑科學;2008年04期

5 姚尚文;盧平;朱衛國;;新湖礦通風系統改造與優化模擬分析[J];煤炭科學技術;2006年11期

6 于建偉;張歡;于燕玲;;污水隧道縱向通風CFD仿真模擬與試驗研究[J];山東建筑大學學報;2007年04期

7 張曉明;李風;謝元一;汪鵬;;秦嶺終南山隧道火災工況下的通風模擬[J];消防科學與技術;2007年06期

8 趙千里,劉劍;用礦井通風仿真系統(MVSS)確定通風系統優化改造方案[J];中國安全科學學報;2002年02期

9 高建良,張生華;壓入式局部通風工作面風流分布數值模擬研究[J];中國安全科學學報;2004年01期

10 漆旺生,蔡嗣經,沈士成;祁南煤礦通風系統分析與優化[J];中國安全科學學報;2004年02期

本文編號：1789587