鋼管混凝土柱沖擊動力響應的等效單自由度方法研究
發布時間：2018-10-04 19:10
【摘要】：鋼管混凝土結構憑借承載力高、抗震性能優越、施工簡便等諸多優點在工程項目中得到廣泛應用。作為承重構件的鋼管混凝土柱如果遭受到橫向沖擊等偶然荷載作用,將會造成重大的人員傷亡和財產損失。本文先采用LS-DYNA有限元軟件對軸壓作用下的鋼管混凝土柱的抗沖擊性能展開研究,然后基于等效單自由度方法,計算鋼管混凝土柱的沖擊動力響應。研究?jī)?nèi)容如下:1.根據試驗結果,驗證了 LS-DYNA軟件計算的可靠性。然后建立了兩種不同鋼管壁厚的構件有限元模型。計算結果發現,當沖擊高度較小時,在一定的軸壓比范圍內,適當施加軸力能夠提高鋼管混凝土構件的抗沖擊性能;當沖擊高度較大時,即使在較小的軸壓比范圍內,軸力的存在也會急劇削弱鋼管混凝土構件的抗沖擊性能。2.從仿真結果可以看出,軸壓作用下的鋼管混凝土柱的沖擊力時程曲線一般分為具有平臺段和沒有平臺段兩種形式,為了便于等效單自由度方法的計算,按照沖量相等的原則將實際復雜的沖擊力時程曲線簡化為矩形脈沖和三角形脈沖形式,在一定情況下得到的位移誤差較小。3.推導了軸壓作用下鋼管混凝土柱受跨中沖擊等效單自由度體系的運動微分方程,并給出了矩形脈沖和三角形脈沖荷載的位移響應通解。采用等效單自由度方法計算了各種仿真工況的位移響應,對比位移最大值發現,當沖擊速度較小時,一般可以將沖擊力時程簡化成矩形脈沖荷載,此時得到的最大位移值與LS-DYNA的仿真結果誤差較小;當沖擊速度較大時,一般需要將沖擊力時程簡化成三角形脈沖荷載,此時計算結果的誤差比矩形脈沖相對較大;在小軸壓范圍內,軸壓比增大時,誤差會減小;增加鋼管厚度,結構產生的位移減小,誤差也減小。
[Abstract]:Concrete filled steel tube (CFST) structure is widely used in engineering projects by virtue of its high bearing capacity, superior seismic performance and easy construction. Concrete-filled steel tubular columns as load-bearing members will cause heavy casualties and property losses if they are subjected to accidental loads such as lateral impact. In this paper, the impact resistance of concrete-filled steel tubular columns under axial compression is studied by using LS-DYNA finite element software, and then the impact dynamic response of concrete filled steel tubular columns is calculated based on the equivalent single-degree-of-freedom method. The research is as follows: 1. According to the experimental results, the reliability of LS-DYNA software calculation is verified. Then two kinds of finite element models of steel tube with different wall thickness are established. The results show that when the impact height is small and the axial compression ratio is within a certain range, the proper application of axial force can improve the impact resistance of concrete-filled steel tubular members, and when the impact height is large, even in a small axial compression ratio range, The impact resistance of concrete filled steel tubular (CFST) members will be greatly weakened by the existence of axial force. From the simulation results, it can be seen that the impact time history curve of concrete-filled steel tubular columns under axial compression is generally divided into two forms: the stage section and the non-platform section. In order to facilitate the calculation of the equivalent single-degree of freedom method, According to the principle of equal impulse, the actual complex time history curve of impact force is simplified into rectangular pulse and triangular pulse, and the displacement error is smaller. 3. The differential equations of motion of concrete-filled steel tubular columns under axial compression are derived and the displacement responses of rectangular and triangular impulsive loads are given. The displacement response of various simulation conditions is calculated by using the method of equivalent single degree of freedom. By comparing the maximum displacement with the maximum displacement, it is found that when the impact velocity is small, the time history of impact force can be simplified into rectangular pulse load. When the impact velocity is large, the time history of impact force should be simplified as triangular pulse load, and the error of the calculated result is larger than that of rectangular pulse. In the small axial compression range, when the axial compression ratio increases, the error will decrease, and the displacement and error of the structure will decrease with the increase of the steel tube thickness.
【學位授予單位】：西南交通大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TU398.9
[Abstract]:Concrete filled steel tube (CFST) structure is widely used in engineering projects by virtue of its high bearing capacity, superior seismic performance and easy construction. Concrete-filled steel tubular columns as load-bearing members will cause heavy casualties and property losses if they are subjected to accidental loads such as lateral impact. In this paper, the impact resistance of concrete-filled steel tubular columns under axial compression is studied by using LS-DYNA finite element software, and then the impact dynamic response of concrete filled steel tubular columns is calculated based on the equivalent single-degree-of-freedom method. The research is as follows: 1. According to the experimental results, the reliability of LS-DYNA software calculation is verified. Then two kinds of finite element models of steel tube with different wall thickness are established. The results show that when the impact height is small and the axial compression ratio is within a certain range, the proper application of axial force can improve the impact resistance of concrete-filled steel tubular members, and when the impact height is large, even in a small axial compression ratio range, The impact resistance of concrete filled steel tubular (CFST) members will be greatly weakened by the existence of axial force. From the simulation results, it can be seen that the impact time history curve of concrete-filled steel tubular columns under axial compression is generally divided into two forms: the stage section and the non-platform section. In order to facilitate the calculation of the equivalent single-degree of freedom method, According to the principle of equal impulse, the actual complex time history curve of impact force is simplified into rectangular pulse and triangular pulse, and the displacement error is smaller. 3. The differential equations of motion of concrete-filled steel tubular columns under axial compression are derived and the displacement responses of rectangular and triangular impulsive loads are given. The displacement response of various simulation conditions is calculated by using the method of equivalent single degree of freedom. By comparing the maximum displacement with the maximum displacement, it is found that when the impact velocity is small, the time history of impact force can be simplified into rectangular pulse load. When the impact velocity is large, the time history of impact force should be simplified as triangular pulse load, and the error of the calculated result is larger than that of rectangular pulse. In the small axial compression range, when the axial compression ratio increases, the error will decrease, and the displacement and error of the structure will decrease with the increase of the steel tube thickness.
【學位授予單位】：西南交通大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TU398.9
【相似文獻】
相關期刊論文 前10條
1 陸長庚;;超級高強度混凝土柱[J];建筑知識;1988年05期
2 劉愛忠;;混凝土柱模卡具的改進[J];建筑工人;1998年03期
3 翟海寧;關于清水混凝土柱的施工要求[J];小城鎮建設;1999年03期
4 徐德新,劉小明,楊勇華,侯發亮,孟吉復,褚江濤,余震;爆裂混凝土柱的試驗分析[J];工業建筑;2001年05期
5 周越洲,吳敬偉;鋼管混凝土柱與普通混凝土柱的經濟性比較[J];廣東土木與建筑;2004年03期
6 肖巖,何文輝,毛小勇;約束鋼管混凝土柱的開發研究(英文)[J];建筑結構學報;2004年06期
7 劉萬鋒;混凝土柱的破壞及原因分析[J];建筑安全;2005年10期
8 ;混凝土柱上加鋼梁的相關問題探討[J];工業建筑;2006年11期
9 李哲;;鋼管混凝土柱在高層建筑中的應用[J];福建建材;2007年02期
10 周海娜;申可可;;淺談某工程鋼管混凝土柱施工[J];建材與裝飾(中旬刊);2007年09期
相關會議論文 前10條
1 蔡文博;灻玉麟;_5智m，
本文編號：2251530
本文鏈接：http://sikaile.net/jianzhugongchenglunwen/2251530.html
最近更新
教材專著
