本文關鍵詞： 建筑節能 �；⒅楸匕� 正交試驗 導熱系數 性能優化　出處：《北方工業大學》2017年碩士論文　論文類型：學位論文

【摘要】：本文針對現有�；⒅楸匕灞匦阅懿�、干密度大、強度低等缺點,從原材料的選用、配比優化等方面出發,建立保溫板的性能檢測方法,采用正交試驗對保溫板配比進行研究,通過極差、方差等分析方法,得到初步配比,再采用配比優化試驗并考慮保溫板綜合性能,得到試驗最優配比,最終研制出性能更優的�；⒅楸匕�。主要研究內容如下:1.通過比較分析現有�；⒅楸匕褰M成材料的優缺點,選定試驗原材料;同時對比分析現行相關試驗標準,確定玻化微珠保溫板各項性能測試標準。以普通�；⒅楸厣皾{基本配比為基礎,考慮干密度、抗壓強度、稠度三項指標,根據試驗確定本文較適宜的�；⒅槎逊e密度和試驗用水量。2.通過分析現有�；⒅橄嚓P(guān)規范,制定本文試驗配比考核指標。采用四因素三水平正交試驗,以保溫板干密度、導熱系數、抗壓強度為評價指標,通過極差、方差等分析方法研究玻化微珠摻量、水泥摻量、纖維水鎂石絨摻量以及復合外加劑種類四種因素對三項指標的影響,得出影響保溫板性能指標的主次因素及顯著性并初步確定�；⒅楸匕逶囼炁浔取Ｔ诖嘶A(chǔ)上對試驗配比進一步優化,并考慮保溫板抗折強度、線性收縮率、抗凍性等各項性能,在滿足試驗配比考核指標和優于現有珍珠巖等無機防火保溫板性能前提下,確定保溫板最佳配合比。3.將�；⒅楸匕鍛�(yīng)用于常用墻體,通過熱工計算,得出滿足北方地區65%節能要求玻化微珠保溫板的最小厚度。參考珍珠巖保溫板工程技術規程制定膨脹�；⒅楸匕逡�(guī)格尺寸,并設計外墻保溫隔熱系統基本構造,提出保溫板施工方法。
[Abstract]:Aiming at the shortcomings of the existing glass bead insulation board, such as poor thermal insulation performance, high dry density and low strength, the performance testing method of the thermal insulation board is established from the aspects of raw material selection, proportion optimization and so on. Orthogonal test was used to study the proportion of insulation board. Through the analysis of extreme difference and variance, the initial proportion was obtained, and the optimum ratio was obtained by optimizing the ratio test and considering the comprehensive performance of the insulation board. The main research contents are as follows: 1. By comparing and analyzing the advantages and disadvantages of the existing glass bead insulation board, the experimental raw materials are selected. At the same time, by comparing and analyzing the current relevant test standards, the performance test standards of vitrified microbead insulation board are determined. Based on the basic ratio of ordinary glass microbead insulation mortar, three indexes of dry density, compressive strength and consistency are considered. According to the test, the proper packing density and water consumption of the glass beads were determined. Through the analysis of the existing relevant specifications of the glass beads, the test proportioning assessment index was established, and the four factors and three levels orthogonal test was adopted. The dry density, thermal conductivity and compressive strength of the thermal insulation board were taken as the evaluation indexes. The content of glass microbeads and cement was studied by means of extreme difference and variance analysis. The influence of fiber brucite content and compound admixture on the three indexes. The main and secondary factors affecting the performance of the thermal insulation board and its significance were obtained, and the experimental ratio of the glass microbead insulation board was preliminarily determined. On this basis, the test ratio was further optimized, and the bending strength and linear shrinkage of the thermal insulation board were considered. On the premise of meeting the test ratio and testing index and surpassing the existing performance of inorganic fire insulation board such as perlite. Determine the best proportion of heat preservation board. 3. Apply glass microbead insulation board to common wall, through thermal calculation. The minimum thickness of vitrified microbead insulation board is obtained to meet the energy saving requirements of 65% in North China. The specifications and dimensions of expanded glass bead thermal insulation board are formulated with reference to the engineering technical specification of perlite thermal insulation board. The basic structure of exterior wall thermal insulation system is designed, and the construction method of thermal insulation board is put forward.
【學位授予單位】：北方工業大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TU551

【參考文獻】

相關期刊論文 前10條

1 林光;;減水劑在混凝土中的應用[J];江西建材;2016年17期

2 季海峰;李珠;霍英濤;;玻化微珠保溫砂漿在防火構造中的應用[J];消防科學與技術;2015年01期

3 吳杰;吳迎春;黃健;;發泡水泥板工業化生產的研究與應用[J];建筑施工;2014年12期

4 吳姝嫻;楊正宏;蘇宇峰;;無機保溫板的研制及熱工性能計算[J];新型建筑材料;2014年09期

5 歐冰;;淺談我國建筑節能現狀與措施[J];科技展望;2014年16期

6 毛戰紅;;不同硅酸鈣板導熱系數探討[J];中國建材科技;2014年03期

7 董偉;;外墻外保溫用防火保溫材料簡析[J];墻材革新與建筑節能;2014年06期

8 張玉輝;;建筑外墻保溫用巖棉發展?fàn)顩r分析[J];墻材革新與建筑節能;2013年10期

9 王愛兵;;淺析建筑節能現狀及建筑節能新技術[J];城市建筑;2013年16期

10 馮銘;楊聰武;;淺談硅酸鈣板的生產與應用[J];新型建筑材料;2012年11期

相關碩士學位論文 前10條

1 閆興辰;截面形式對超薄型防火涂料防火性能影響的試驗研究[D];北方工業大學;2015年

2 王乃濤;無機防火保溫板外墻外保溫系統質量管理與評價研究[D];大連理工大學;2014年

3 高中山;外墻外保溫系統防火技術的研究分析[D];遼寧工業大學;2014年

4 李娟;纖維增強復合材料保溫板的制備研究及應用[D];揚州大學;2013年

5 王剛;新型夾芯保溫復合墻板性能研究[D];安徽建筑大學;2013年

6 楊華峰;耐火輕質保溫板的研制與性能[D];合肥工業大學;2013年

7 陳曉莉;�；⒅楸厣皾{基本性能的試驗研究與應用[D];安徽理工大學;2012年

8 劉思林;無機輕集料保溫砂漿防火性能的研究[D];湖南大學;2012年

9 袁波;�；⒅榘l(fā)泡保溫板的研制及應用分析[D];太原理工大學;2012年

10 周華杰;�；⒅閺�(fù)合保溫板的研究[D];太原理工大學;2012年

，

本文編號：1453598