本文選題：并行測試 + TTCN-3��； 參考：《內蒙古大學》2014年碩士論文

【摘要】：并行測試是指測試系統并行地對被測系統進行測試。通過并行測試能夠減少測試時間以及其它開銷,提高測試效率。TTCN-3語言的重要語言特性之一就是并行測試。傳統協議測試中要使用多臺測試機在該網絡的多個位置分別模擬不同協議角色,而基于TTCN-3的并行測試方案,可以通過使用一臺主測試機同時模擬多個協議角色,實現協議并行測試。OpenFlow是一種新型網絡交換模型。OpenFlow協議用來描述OpenFlow網絡中控制器和交換機之間交互所用信息的標準,并給出了控制器和交換機的接口標準。目前對于OpenFlow的研究和應用十分廣泛,但是對于OpenFlow協議測試方面的研究工作還不夠充分。 本文主要研究用TTCN-3對OpenFlow協議進行并行測試研究與實踐。通過仔細研讀和分析OpenFlow協議規范進行TTCN-3ATS以及測試場景的設計。其中較為系統地介紹了用TTCN-3進行簡單測試和并行測試測試?yán)脑O(shè)計步驟以及實現過程。通過設計并實現編解碼、適配器部分與被測對象進行信息的交互。然后搭建典型的實驗環境,分別用TTCN-3模擬交換機和控制器,對控制器和交換機進行測試。分析測試結果,將簡單測試與并行測試進行對比,通過實驗分析并行測試的特點和優勢。最后,對全文總結并給出下一步工作的研究方向。
[Abstract]:Parallel testing refers to the test system to test the system under test in parallel. Parallel testing is one of the most important language features of TTCN-3, which can reduce the test time and other overhead. In the traditional protocol testing, many test machines are used in the network to simulate different protocol roles, while the TTCN-3 based parallel testing scheme can simulate multiple protocol roles simultaneously by using a single main tester. Implementing protocol parallel testing. OpenFlow is a new network switching model. OpenFlow protocol is used to describe the information used between controller and switch in OpenFlow network. The interface standard between controller and switch is also given. At present, the research and application of OpenFlow is very extensive, but the research work of OpenFlow protocol testing is not enough. In this paper, we mainly study and practice the parallel testing of OpenFlow protocol with TTCN-3. TTCN-3 ATS and test scenarios are designed by carefully reading and analyzing the OpenFlow protocol specification. The design steps and implementation process of simple test and parallel test cases with TTCN-3 are introduced systematically. By designing and implementing the codec, the adapter part interacts with the object under test. Then a typical experimental environment was built, and TTCN-3 was used to simulate the switch and controller, and the controller and switch were tested. The characteristics and advantages of parallel test are analyzed by comparing simple test with parallel test. Finally, the paper summarizes the full text and gives the research direction of the next work.
【學位授予單位】：內蒙古大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TP393.04

【參考文獻】

相關期刊論文 前4條

1 王冠;吳際;徐珞;金茂忠;;面向TTCN-3分布式測試執行平臺的測試適配器框架的研究與設計[J];電子學報;2009年S1期

2 謝靈智;;網絡架構革命:SDN與OpenFlow開始燎原?[J];信息安全與通信保密;2012年09期

3 王瑋;黃小紅;常婧;柯宏力;馬嚴;;基于TTCN-3的移動IPv6并行測試的設計與實現[J];廈門大學學報(自然科學版);2007年S2期

4 ;外刊[J];中國海關;2012年07期

，

本文編號：2097012